Thermal Power RO Concentrate: Why It Resists Conventional Treatment and Where Ozone Flotation Fits
Reverse osmosis solves one problem and creates another. In a thermal power plant's water treatment system, RO membrane treatment turns boiler make-up water into reusable permeate — about 75% of the feed — while the remaining 25% or so becomes high-salinity concentrate loaded with salts, dissolved solids and organic matter. That concentrate is difficult to treat precisely because everything the membranes rejected is now sitting in it, at higher concentration, with a strong tendency to scale and corrode. Direct discharge would seriously harm the environment.
Why RO Concentrate Is a Hard Target
Three properties make the stream stubborn. High salt content means most biological and many physical processes struggle or fail. Heavy metal ions and organic pollutants ride along with the salts, complicating any recovery scheme. And the combination of high salinity with high organic content drives up treatment cost, makes the technology complex, and produces a strong tendency to membrane fouling and scaling — the very failure that produced the concentrate in the first place.
The Conventional Menu and Its Trade-Offs
- Nanofiltration: two-stage nanofiltration in series purifies sodium chloride; the permeate can be used to prepare regeneration solution, while high-calcium concentrate is treated in a crystallisation pond to remove calcium sulphate and convert the acid.
- Electrodialysis (ED): an electric field efficiently concentrates the wastewater, raising the salt mass fraction above 20% and water recovery above 90%, which lowers the cost of zero liquid discharge.
- Evaporative concentration and crystallisation: low-temperature evaporation efficiently concentrates the wastewater, reduces its volume, saves energy, achieves zero liquid discharge and recovers salt resources.
The integrated route — pre-treatment plus membrane technology plus evaporative crystallisation — removes suspended solids and hardness first, concentrates the water further with membranes, and finally recovers salts through evaporative crystallisation for true zero liquid discharge. It works, but the challenges remain what they always were: high salinity and high organic content, high treatment cost, complex technology and relentless membrane fouling. New membrane materials and processes will raise efficiency and lower costs over time, enabling resource recovery and supporting the sustainable development of thermal power plants.
The CDOF Route for the Organic Fraction
To treat RO concentrate carrying high concentrations of salts, dissolved solids and organic matter, SINOKLE has proposed a new process based on its independently developed products. The core is the CDOF (Cyclonic Dissolved Ozone Flotation Unit), an advanced ozone catalytic oxidation technology that creatively combines advanced ozone oxidation, cyclonic technology and dissolved gas flotation to achieve efficient, comprehensive removal of pollutants from a wide range of hard-to-treat wastewaters.
Ozone catalytic oxidation brings a short flow, simple equipment, small compact treatment units, a small footprint, few electrical devices, low power consumption and low operating cost. Operation is convenient with automatic control that simplifies on-site requirements, and when water quantity and quality change the process can be adjusted accordingly, giving strong adaptability and shock load tolerance. It can also be combined with other technologies — biological treatment, for instance — to exploit their respective strengths and improve overall treatment performance. For RO concentrate specifically, the combination matters because the stream contains almost no biodegradable matter: biological polishing has nothing to feed on, so the organic load must be oxidised chemically, and the cyclonic field plus fine bubbles gives the ozone the contact time and interfacial area it needs to do that work in a compact vessel.
A key enabler is the micro/nano bubble generation system built around efficient gas dissolution, release and mixing equipment. Micro/nano bubbles are extremely fine bubbles smaller than 50 μm in diameter; they rise slowly in water, stay for a long time, dissolve efficiently, self-oxygenate, carry negative charges and are rich in strongly oxidising free radicals — properties that put reactive chemistry in prolonged contact with the pollutants conventional bubbles miss.
What the Laboratory Numbers Show
Laboratory treatment of the concentrate demonstrates the effect visually — raw water beside CDOF-treated effluent — and quantitatively. At an ozone dose of 500 mg/L, COD is 89.55 mg/L and the COD removed is 410.45 mg/L, indicating highly effective COD treatment, with an ozone dosing ratio of 1.21. For a stream this concentrated, removing that much COD per unit of ozone is the difference between an affordable polishing stage and an uneconomic one.
Reading the Whole Picture
RO concentrate management in thermal power plants is heading toward integrated schemes: salts recovered through crystallisation or electrodialysis, organics and residual COD stripped by ozone-based advanced oxidation, and water recovery pushed as high as the salt balance allows. The SINOKLE CDOF-based process addresses exactly the organic leg of that triangle, and its laboratory data — COD reduced to 89.55 mg/L at a 500 mg/L ozone dose with 410.45 mg/L removed — shows the chemistry already works at plant-relevant concentrations. Plants planning zero liquid discharge retrofits should evaluate the organic destruction stage early, because sizing every downstream evaporator depends on how much COD the front end removes.