Beyond the Ozone Tank: Rethinking Advanced Wastewater Treatment With CDFU and CDOF
As discharge requirements tighten year by year, advanced wastewater treatment has stopped being an afterthought and become the battleground where plant economics are decided. SINOKLE approaches it with two in-house technologies — the CDFU (cyclonic dissolved gas flotation) and the CDOF (integrated advanced ozone oxidation flotation unit) — and the pairing changes what an advanced treatment stage can realistically deliver.
Where Conventional Advanced Treatment Falls Short
The standard recipe — a coagulation sedimentation tank plus an ozone oxidation tank — carries a long list of drawbacks that operators know too well. Treatment performance is unstable and cannot reliably meet Class 1A standards. Equipment reliability and automation are low, so adaptability and shock resistance suffer whenever water quality fluctuates and system stability erodes. Large doses of flocculant and other chemicals are needed, which inflates cost and produces more sludge. Ozone consumption reaches 100%, keeping operating costs high. Open operation allows ozone to escape and cause secondary pollution, creating significant safety and environmental risk. And the flotation tank occupies a large area, takes a long time to build and install, and is strongly affected by weather and labour factors.
How the New Train Is Wired
The new SINOKLE advanced treatment process puts the CDOF at its core with the CDFU doing pre-treatment. Biological effluent first flows into the CDFU, where part of the suspended solids and COD are effectively removed; CDFU uses ozone gas as its gas source and discharges its scum to the scum tank. Water pre-treated by the CDFU then enters the CDOF for advanced treatment. That unit also runs on ozone gas as its gas source, and through multiple catalytic oxidation it rapidly degrades COD in the water, producing effluent that is colourless, transparent and reliably within standard; the CDOF backwash water joins the scum stream as well. Because both units use ozone gas rather than air as their gas source, no extra blower train is needed, and the shared scum tank collects everything the two stages strip out in one place for handling.
What the Numbers Say
- Flow and efficiency: the train is short and highly efficient with strong shock resistance, bringing effluent within standard reliably.
- Technology: several invention patents back the design; COD degradation and decolourisation are strong, and the ozone dose is only one half to one quarter of a conventional process, greatly reducing energy consumption.
- Speed and space: CDOF's multiple catalytic oxidation accelerates the reaction to a retention time of under 15 minutes, and the skid-mounted design takes only one fifth of the footprint of a conventional process.
- O&M: the patented processes of CDFU and CDOF ensure stable, reliable treatment and convenient maintenance; fully automated enclosed pressure operation eliminates ozone leakage, and the fully automated, digitalised operating mode supports remote monitoring, trimming labour requirements and O&M costs.
- Chemicals: essentially none — a sharp contrast with conventional processes that depend on large amounts of flocculant.
- Operating cost: ozone consumption drops to 20-25% of the conventional figure, a clear cost advantage.
- Safety and environment: fully enclosed pressurised operation avoids secondary pollution and safety hazards.
- Lead time: skid-mounted equipment shortens the construction, installation and commissioning cycle and shrinks the site demand.
The process indicators make the improvement concrete: influent COD ≤200 mg/L and colour ≤200 turn into effluent COD ≤40 mg/L and colour ≤20 — a marked improvement. Real projects have already run the train, and the case results demonstrate its feasibility and effectiveness convincingly.
Why the Ozone Dose Matters More Than the Ozone Tank
Ozone is usually the single most expensive input in an advanced treatment stage, which is why the dose ratio deserves attention. A conventional open tank wastes much of what it feeds: unreacted ozone strips out of the water surface, and whatever does dissolve competes with scavengers instead of pollutants. Running the reaction inside a closed pressurised vessel changes the balance — gas stays in contact with the water, catalytic surfaces split the ozone into the reactive species that actually attack COD, and the same removal is achieved with a fraction of the generation capacity. Shorter retention compounds the saving: a train that finishes in under 15 minutes needs smaller blowers, smaller tanks and less standby power, and those savings repeat every operating hour for the life of the plant.
Where This Leaves Plant Operators
Compared line by line — treatment performance, stability, cost control, safety and environmental protection — the CDFU-plus-CDOF configuration outperforms the conventional route at every point where the conventional route leaks value. For plants whose biological stage is healthy but whose tertiary stage keeps missing Class 1A, the attraction is obvious: ozone bought at a fraction of the dose, no flocculant bill, a footprint that fits crowded sites, and an operation that no longer depends on weather windows or headcount. SINOKLE expects the configuration to play a bigger role across the environmental field and to keep driving progress in wastewater treatment technology.