Home News Knowledges RO Concentrate: What a Laboratory Ozonation Trial Says about the Stream You Cannot Permeate

RO Concentrate: What a Laboratory Ozonation Trial Says about the Stream You Cannot Permeate

2026-11-16 5 readings

Reverse osmosis (RO) membrane separation is an advanced liquid purification method. Compared with conventional treatment it offers significant cost efficiency, simple operation and maintenance, no acid or alkali dosing and a compact footprint, and it is therefore widely used in seawater and brackish water desalination, ultrapure water production, and the concentration and recovery of chemical materials. As membrane products diversify, membrane performance improves and systems are optimised, the technology is increasingly applied to municipal wastewater reuse and industrial wastewater purification.

How RO Splits the Feed, and What It Leaves Behind

RO uses pressure, typically 1-10 MPa, to drive water molecules through a selective separation membrane, thereby separating, extracting, refining and concentrating materials. It removes salts and ionic species effectively and also retains organic matter, colloids, bacteria and viruses well. In operation an RO membrane converts roughly 80-85% of the feed into clean permeate, while all the retained substances collect in a concentrate that accounts for 15-20% of the feed volume, with pollutant concentrations typically 2 to 3 times those of the feed. If this high-salinity, high-organic concentrate is not handled properly, it not only wastes a valuable water resource but can also cause serious environmental pollution.

What Is Actually in the Concentrate

Concentrate quality depends mainly on the feed source. Concentrate from wastewater treatment systems usually has significantly higher conductivity, total dissolved solids and chloride content than the brine produced by seawater desalination. Its composition is dominated by dissolved inorganic salts and by small, soluble, poorly degradable organic molecules.

The organic fraction may include hard-to-degrade chemicals from domestic wastewater such as pesticides, personal care products, pharmaceutical residues and endocrine disruptors; residues generated during treatment such as soluble microbial products, partially biodegraded organics and antiscalants; and various biomass including bacteria, viruses, oocysts and cell debris. All of these pose a potential threat to the ecosystem. The inorganic salts consist mainly of chloride, carbonate, bicarbonate, sulfate and nitrate, together with calcium, magnesium and sodium cations.

The CDOF Answer to Concentrate

Given the large volume and high salt content of RO concentrate, and guided by the principles of zero liquid discharge and resource recovery, SINOKLE has introduced an innovative treatment route, high-efficiency catalytic ozonation, dedicated to the challenge of this stream. The process is the proprietary CDOF, a Cyclonic Dissolved Ozone Flotation unit which creatively combines advanced ozone oxidation, cyclone separation and dissolved gas flotation to achieve efficient, integrated removal of a wide range of refractory pollutants.

Catalytic ozonation has a short process flow and simple equipment. The treatment units are small and compact and the footprint is limited; few electrical devices are needed and power consumption is low, so operating costs stay low. Operation is convenient and can be automated, which simplifies on-site requirements. When flow or water quality changes, the process can be adjusted accordingly, giving strong adaptability and resistance to shock loads. It can also be combined with other technologies such as biological treatment, so that each plays to its strengths and overall treatment performance improves further.

From Laboratory Data to Plant Sizing

Laboratory trials on concentrate answer the question plant engineers always ask first: does the ozone go into the organics or into the salt? The dosing ratio of 1.11 recorded in the trial above settles that concern for this matrix, and it converts directly into sizing arithmetic. A plant concentrates its RO feed differently from the trial rig, so the pollutant load per cubic metre scales, but the ratio holds as the design anchor: expected COD removal divided by 1.11 gives the ozone demand, and the compact footprint of the CDOF vessel keeps the resulting hardware modest even at municipal reuse scale. Because the process tolerates shock loads and adjusts to flow changes, seasonal dilution in the feed does not destabilise the train; the ozone dose simply follows the load. That flexibility is what makes the route combinable with biological polishing where the site already operates it.

The Laboratory Trial on RO Concentrate

The decisive evidence came from a laboratory trial run on actual RO concentrate. With this process and an ozone dose of 200 mg/L, the effluent COD was 53.75 mg/L, the COD removed was 180 mg/L, and the ozone dosing ratio was 1.11.

Those three numbers reward a second look. Removing 180 mg/L of COD with only 200 mg/L of ozone, at a dosing ratio of 1.11, means the oxidation went into the target molecules rather than into side reactions with the heavy salt matrix, which is exactly where plain ozonation on high-salinity streams usually loses its efficiency.

Where This Leaves Concentrate Management

For plants already committed to RO, the concentrate stream is no longer a dead end to be evaporated or discharged under derogation. A compact catalytic ozonation unit that holds effluent COD at 53.75 mg/L on a matrix two to three times saltier than the feed gives operators a compliant discharge route, and one that slots into a zero liquid discharge programme without the evaporation capital that route usually demands.