Heavy Oil Power Plant Oily Wastewater: Choosing a Process That Survives Site Conditions

Heavy Oil Power Plant Oily Wastewater: Choosing a Process That Survives Site Conditions

2026-10-19

Heavy oil wastewater at a power plant is judged less by its chemistry than by the site it has to run on: intermittent discharge, tight plot space, overseas compliance rules and remote maintenance. This article sets out the four constraints that eliminate

Why High-Gravity Mass Transfer Beats Chemical Demulsification on Oily Waste

Why High-Gravity Mass Transfer Beats Chemical Demulsification on Oily Waste

2026-10-19

Chemical demulsification works, but it brings a dosing skid, a sludge stream and a permanent reagent bill. This article examines a purely physical alternative built on cyclonic flow, high-frequency vibration and a high-gravity field, explains why three me

Three Field Cases: How CDFU Plus CDOF Performs on Real Oily Wastewater

Three Field Cases: How CDFU Plus CDOF Performs on Real Oily Wastewater

2026-10-15

Rather than describing a process in the abstract, this article reports three projects where a CDFU plus CDOF pure-physical train was installed and measured: refining and chemical produced water at 1,000 m3/d, a thermal power plant at 500 m3/d, and ship bi

Reinjection Water Quality: Why Emulsified Oil Between 1 and 50 Microns Decides It

Reinjection Water Quality: Why Emulsified Oil Between 1 and 50 Microns Decides It

2026-10-15

As oilfields move into the mid-to-late stage of development, reinjection water quality directly governs waterflood performance and production economics. This article explains why produced water with emulsified droplets between 1 and 50 microns defeats con

Coking Wastewater by the Numbers: What 3,800 mg/L COD Does to Process Choice

Coking Wastewater by the Numbers: What 3,800 mg/L COD Does to Process Choice

2026-10-15

Coking wastewater combines extremely high organic load with phenols, ammonia nitrogen, cyanide and finely emulsified oil, which is why biological treatment alone struggles. This article sets out the load figures first, explains why conventional physicoche

Ship Bilge Water in Three Stages: CDFU, KFM and CDOF Against Grade 3 Limits

Ship Bilge Water in Three Stages: CDFU, KFM and CDOF Against Grade 3 Limits

2026-10-15

Engine room bilge water and tank washing water are highly emulsified and leave little room for error, which is why compliant discharge is a persistent problem for ship operators. This article walks through a three-stage process combining CDFU pre-treatmen

Tank Farm Wastewater: Why Coalescing Plus CDFU Replaces Chemical Demulsification

Tank Farm Wastewater: Why Coalescing Plus CDFU Replaces Chemical Demulsification

2026-10-15

Oil tank farms generate a wastewater stream whose oil content swings from a few hundred mg/L to tens of thousands, and chemical demulsification has trouble keeping up. This article explains where the water comes from, the four characteristics that drive t

Three Units, One Train: Getting Oil Out of Every Power Plant Wastewater Stream

Three Units, One Train: Getting Oil Out of Every Power Plant Wastewater Stream

2026-10-15

A thermal power plant generates oily wastewater from boiler cleaning, desulfurisation and turbine maintenance, and the oil content across those streams can differ by four orders of magnitude. This article explains why settling ponds and plain flotation un

Free Oil in PLA Wastewater Is Recoverable Product, Not Just a Disposal Problem

Free Oil in PLA Wastewater Is Recoverable Product, Not Just a Disposal Problem

2026-10-15

Polylactic acid production sends a steady trickle of un-emulsified free oil into its wastewater, and treating it as waste is an expensive habit. This article traces where that oil enters the stream, from vacuum pump working fluid to heat transfer oil leak

Pharmaceutical Wastewater in Two Moves: CDFU First, CDOF for What Survives

Pharmaceutical Wastewater in Two Moves: CDFU First, CDOF for What Survives

2026-10-15

Pharmaceutical wastewater combines suspended solids, refractory organics and strong toxicity, and batch production makes both quality and volume swing hard. This piece sets out a two-stage design in which CDFU strips the load up front so the catalyst down